Operation Manual

Cash Register CM 910 / 911 / 912
Olympia
2011 Page 65 Specifications subject to change without notice!
11.2 Printer malfunction
1. In the event of a printer error, switch off the cash register immediately and disconnect the power plug.
2. Check that the paper roll is inserted correctly or whether there is a foreign body in the printer mechanism. Remove it,
if present.
Attention: Remove the foreign body very carefully. Do not use a knife, screwdriver or anything similar! Never use force!
This could damage the printer mechanism.
3. Switch the cash register on again and complete a registration.
4. If the printer error reoccurs, contact the service centre.
Note: Never use low quality paper!
12 Options
Various peripheral equipment can be connected to the cash register.
12.1 SD card slot for data backup
Use an SD card to make a backup copy of the current programme data and all reports. If the cash register has a technical
defect or data is lost, you can load the backup copies of the reports and programme on the cash register from the SD
card.
Note: The electronic journal is not
saved on the SD card.
12.1.1 Saving data on an SD card
Note: The SD card should have a capacity of 2 GB.
Input
Display
=SD CARD - 1=
● Set the key to PRG
● Select programme number 81
(refer to Chapter 5.1.2).
● Confirm by pressing CASH.
The options appear in the display.
3
#
SD CARD BACKUP
SD CARD RECOVERY
● Use the  and  keys to
select BACKUP.
● Confirm by pressing CASH.
#
##
3#
The current programme and reports (except the electronic journal) are transferred from the cash register and stored on
the SD card.
Note: During transfer, Please Wait appears in the display.
Never interrupt this process!
12.1.2 Loading data from an SD card
Input Display
=SD CARD - 2=
● Set the key to PRG
● Select programme number 81
(refer to Chapter 5.1.2).
● Confirm by pressing CASH
The options appear in the display.
3
#
SD CARD BACKUP
SD CARD RECOVERY
● Use the  and  keys to
select RECOVERY.
● Confirm by pressing CASH.
#
##
3#
All the data stored (programme and reports) are transferred from the SD card to the cash register.