Operation Manual

Cash Register CM 910 / 911 / 912
Olympia
2011 Page 9 Specifications subject to change without notice!
2 Starting Up
2.1 Inserting a paper roll
Attention: Only use thermal paper!
1. Remove the printer lid.
2. Pivot the paper transport unit up.
3. Insert a thermal paper roll with a width of 57 mm wide and a maximum diameter of 70 mm.
4. Draw the leading edge of the paper over the tear-off edge and pivot the paper transport unit down, locking it in place.
5. Depending on the required use (receipt or journal mode), either tear off the paper at the tear-off edge of the printer
mechanism or feed the paper onto the paper reel.
6. Replace the printer lid.
2.2 Paper reel
The paper reel is required when the receipt should be wound onto it. In this case, journal mode must be activated via
system option 40 (refer to Chapter 5.13).
1. Open the printer lid.
2. Remove the paper reel.
3. Thread the end of the journal paper in the slit in the paper reel.
4. Insert the paper reel in the reel guides provided for it.
5. To remove the journal paper after it has been rolled up on the reel, remove the paper
reel and pull the journal roll off.
6. Reinsert the paper reel.
7. Close the printer lid.
2.3 Language
The texts in the display and on the receipt can be made in four different languages:
● English
● German (default)
● French
● Dutch
Attention: To activate a new language, you must delete all the memories! Observe your obligations in respect of
providing proof and preserving records for the revenue authorities with regard to programming and cash
register reports (refer to Page 61)! Therefore, only change the cash register language before actually putting
it into operation!
To set a language other than German, refer to Chapter 5.3.