Operation Manual

Cash Register CM 940-F / 941-F / 942-F
Olympia
2011 Page 109 Specifications subject to change without notice!
6.32 Programming rounding
The cash register always rounds the totals after pressing the ┣SUB-TOTAL┫ and ┣CASH┫ keys.
6.32.1 Programming rounding for received on account/paid out and for calculating tax
You can define whether calculations for receiving on account / paying out and for tax should be rounded up or down after
selecting the type of rounding required.
If no special European rounding methods are selected, the standard commercial 5/4 rounding is applied:
● If the first decimal place to be rounded is a 0, 1, 2, 3 or 4, the number is rounded down.
● If the first decimal place to be rounded is a 5, 6, 7, 8 or 9, the number is rounded up.
6.32.1.1 Programming rounding for receiving on account / paid out
Significance Rounding code A
Always round down 0
Rounding (according to rounding method selected) 1
Always round up 2
Example: An amount received on account or paid out should always be rounded up.
Input Display
=ROUNDING PO-RA%- 1=
1. Set the key to PRG.
2. Select programme number 50
(see Chapter 6.1.2).
3. Press the ┣CASH┫ key to
confirm the selection.
#

[0]
4. Enter the rounding code using
the digit keys.

[2 ]
5. Save the programmed data by
pressing the ┣CASH┫ key.
#
Save...!!
Please Continue...
6. Conclude programming by
pressing the ┣SUB-TOTAL┫ key.
"