Operation Manual

Cash Register CM 940-F / 941-F / 942-F
Olympia
2011 Page 150 Specifications subject to change without notice!
13 Solving Problems
Attention: The power socket must be close to the cash register and easily accessible. This means that the cash register
can be disconnected from the power supply quickly in an emergency.
13.1 Display messages
Display Cause Corrective measures:
Paper
End of paper roll. Replace a new paper roll.
L
The battery capacity is too low. Charge the battery.
B
Receipt printing is switched off.
Press the RECEIPT ON/OFF key to switch receipt printing
back on.
T
The cash register is in Training
mode;
Press the TRAINING key to deactivate Training mode.
II
Department level 2 is active
Press the DP SHIFT key to switch between the department
levels.
III
Department level 3 is active
Press the DP SHIFT key to switch between the department
levels.
13.2 Printer malfunctions
In the event of a printer error, switch off the cash register immediately and disconnect the power plug!
1. Check that the paper roll is inserted correctly or whether there is a foreign body in the printer mechanism. Remove it,
if present.
Attention: Remove the foreign body very carefully. Do not use a knife, screwdriver or anything similar! Never use force!
This could damage the printer mechanism.
2. Switch the cash register on again and complete a registration.
3. If the printer error reoccurs, contact the service centre.
Note: Never use low quality paper!