Operation Manual

Cash Register CM 940-F / 941-F / 942-F
Olympia
2011 Page 151 Specifications subject to change without notice!
14 Options
Various peripheral equipment can be connected to the cash register.
14.1 SD card slot for data backup
Use an SD card to make a backup copy of the current programme data and all reports. If the cash register has a technical
defect or data is lost, you can load the backup copies of the reports and programme on the cash register from the SD
card.
Note: The electronic journal is saved on the SD card.
Note: The SD card slot is located on the right-hand side of the housing underneath the rectangular, light grey,
rubber cover.
14.1.1 Saving data on the SD card
Note: The SD card should have a capacity of 2 GB.
Input
Display
SD CARD
1. Insert an appropriate SD card
in the SD card slot on the right-
hand side of the device.
2. Set the key to PRG.
3. Select programme number 81
(see Chapter 6.1.2).
4. Press the ┣CASH┫ key to
confirm the selection.
The options appear in the display.
#

SD CARD BACKUP
SD CARD RECOVERY
5. Use the ┣↑┫ and ┣↓┫ keys to
select SD CARD BACKUP.
6. Press the ┣CASH┫ key to con-
firm the selection.


#
>>>>>>>>>>>>>>>>>>>>>>>>
Save...!!
Please Continue...
The current programme settings and reports are copied from the cash register onto the SD card and stored there.
Note: The transfer process is indicated in the display during data transfer.
Never interrupt this process! Then disconnect the cash register briefly from the mains power supply.
14.1.2 Loading data from the SD card
Input Display
SD CARD
1. Insert an appropriate SD card
in the SD card slot on the right-
hand side of the device.
2. Set the key to PRG.
3. Select programme number 81
(see Chapter 6.1.2).
4. Press the ┣CASH┫ key to
confirm the selection.
The options appear in the display.
#

SD CARD BACKUP
SD CARD RECOVERY
5. Use the ┣↑┫ and ┣↓┫ keys to
select SD CARD RECOVERY.
6. Press the ┣CASH┫ key to
confirm the selection.


#
>>>>>>>>>>>>>>>>>>>>>>>>
Save...!!
Please Continue...
All the data stored (programme and reports) is transferred from the SD card to the cash register.
Note: The transfer process is indicated in the display during data transfer.
Never interrupt this process! Then disconnect the cash register briefly from the mains power supply.