Operation Manual

Cash Register CM 940-F / 941-F / 942-F
Olympia
2011 Page 71 Specifications subject to change without notice!
6.13 Programming the training pass code
You can enter a 6-digit password (pass code) for Training mode which must then be entered each time a clerk wants to
operate the cash register in Training mode.
Example: 123456 should be programmed as the training code.
Input Display
=PASS CODE 1 =
1. Set the key to PRG.
2. Select programme number 11
(see Chapter 6.1.2).
3. Press the ┣CASH┫ key to confirm
the selection.
#

TRAINING CODE
New CODE
4. Enter the existing code (default
setting 000000) in the TRAINING
CODE input area.
Note: Always enter the pass
code as a 6-digit number!
5. Press the ┣CASH┫ key to confirm
the input.




#
****** TRAINING CODE
6. Enter a new 6-digit code in the
NEW CODE input area (digits
only).
7. Press the ┣CASH┫ key to confirm
the input.




#
****** New CODE
8. Repeat the pass code input in
the CONFIRM CODE input area.




****** Confirm CODE
9. Press the ┣CASH┫ key to confirm
the input.
#
Save...!!
Please Continue...
10. Conclude clerk programming by
pressing the ┣SUB-TOTAL┫ key.
"