Operation Manual
Cash Register CM 940-F / 941-F / 942-F
Olympia
2011 Page 90 Specifications subject to change without notice!
6.22 Programming logo messages
The logo message, printed at the top of the receipt, can contain up to 8 lines and a maximum of 32 characters per line.
Four logo lines are already pre-programmed.
Note:
● If you do not want to print a logo message, you can delete the pre-programmed logo message lines.
● The way to enter texts is described in Chapter 6.2.
● Text lines which are not programmed are not printed.
● Only 20 characters of a line can be shown in the display. However, a line on the receipt may contain up to 32
characters! The display inserts a line feed in the text after 20 characters and displays the last 12 characters of the logo
message in a second line.
Note: Only 4 logo message lines can be programmed directly using the cash register. All 8 logo message lines can
be programmed using the PC programme.
Example: A logo should be programmed containing the text "********* WELCOME *********". The remaining pre-
programmed lines should be deleted.
Input Display
LOGO MESSAGE -1=
********************************
OLYMPIA CM940
45525 Hattingen
********************************
1. Set the key to PRG.
2. Select programme number 31
(see Chapter 6.1.2).
3. Press the ┣CASH┫ key to confirm
the selection.
The programmed logo message
appears in the display. The first logo
line is already selected.
#
4. Press the ┣CASH┫ key to open
the first logo message line for
programming the text.
Note: Only 20 characters can appear
as a line in the display at one time but
32 characters are possible on the
receipt.
#
********************
* * * * * * * * * * * *
5. Delete the existing logo message
by pressing the ┣CLR┫ key.
6. Enter the new logo message.
Procedure
refer to Chapter 6.2
********* WELCOME *********
7. Press the ┣CASH┫ key to save the
input.
#
********* WELCOME *********
8. Use the ┣↑┫ and ┣↓┫ keys to
move to the next logo line.
9. Continue programming the text
as described.
etc.
10. Conclude programming by press-
ing the ┣SUB-TOTAL┫ key.
"