Operation Manual

Cash Register CM 940-F / 941-F / 942-F
Olympia
2011 Page 95 Specifications subject to change without notice!
6.25 Programming order messages
Note: Order receipts / order types are only available when the cash register is operated in its restaurant version
(see Chapter 6.30).
Order types ensure that PLUs with the same order number are printed on the same order message (also see Chapter
6.5.1.8). This means that all orders from guests can be printed properly sorted and are transferred to the relevant section
within the gastronomy (bar, kitchen, ice-cream parlour, cocktail bar, etc.). This ensures that no order is forgotten.
The order messages with different order numbers are printed in succession. Order message indicate the sections and
appear at the top of the order messages.
Up to 9 order messages can be programmed, each with a maximum of 18 characters.
Example: The order message "food" should be programmed for memory location 5.
Input Display
ORDER MESSAGE 1-01
1. Set the key to PRG.
2. Select programme number 41
(see Chapter 6.1.2).
3. Press the ┣CASH┫ key to confirm
the selection.
#

[ ]name
ORDER MESSAGE 5-01
4. Use the ┣CASH┫ key to switch to
the required memory location.
4x #
[ ]name
5. Use the ┣↑┫ and ┣↓┫ keys to
move to the [ ] Name input area.

[ ]name
6. Press the ┣CASH┫ key to confirm
the selection.
#
7. Enter the required order mes-
sage (max. 18 characters) (see
Chapter 6.2).
Procedure
refer to Chapter 6.2
Food
8. Press the ┣CASH┫ key to confirm
the input.
#
[Food ]name
9. Conclude programming by press-
ing the ┣SUB-TOTAL┫ key.
"