Operation Manual

Cash Register CM 980-SF / 980-F / 960-SF / 962-SF
Olympia
2012 Page 78 All Rights Reserved!
6.15 Programming the training pass code
You can enter a 6-digit pass code for Training mode which must then be entered each time a clerk wants to operate the
cash register in Training mode.
Example: 123456 should be programmed as the training pass code.
Input Display
=PASS CODE 0 1
1. Set the key to PRG.
2. Select programming number
11 (see Chapter 6.1.2).
3. Press the ┣CASH┫ key to confirm
the input.

TRAINING CODE
NEW CODE
4. Enter the current pass code (de-
fault setting: 000000) in the
TRAINING CODE input area.
Note: Always enter the pass
code as a 6-digit number!
5. Press the ┣CASH┫ key to confirm
the input.




****** TRAINING CODE
6. Enter a new 6-digit pass code in
the NEW CODE input area.
7. Press the ┣CASH┫ key to confirm
the input.




****** NEW CODE
8. Enter the pass code again in the
Confirm CODE input area.



****** Confirm CODE
9. Press the ┣CASH┫ key to confirm
the input.

Save...!!
Please Continue...
10. Conclude clerk programming by
pressing the ┣SUB-TOTAL┫ key.
