Operation Manual

Cash Register CM 980-SF / 980-F / 960-SF / 962-SF
Olympia
2012 Page 91 All Rights Reserved!
6.21 Programming foreign currencies
A maximum of 2 foreign currencies can be programmed.
Note: If you want to operate with the second foreign currency, you must programme the ┣FC 2┫ key on the keyboard
(see Chapter 6.33). The ┣FC 1┫ key, already setup on the flat keyboard of the CM 980-F at the factory, only
applies to foreign currency 1.
Clarify the following before starting with the actual programming operation:
• Which foreign currency should be programmed?
• In which memory location should this foreign currency be programmed?
• What text is associated with the foreign currency (e.g. the currency abbreviation in accordance with ISO 4217)?
• What is the exchange rate (foreign currency to local currency)?
Example: US Dollar should be programmed as the foreign currency in memory location 2. The exchange rate at the
time of programming was 1 EUR = 1.35 USD (native currency = 1 EUR, foreign currency = 1.35 USD).
Input Display
FC 0 1 1
1. Set the key to PRG.
2. Select programming number 16
(see Chapter 6.1.2).
3. Press the ┣CASH┫ key to confirm
the input.
The first foreign currency memory
location appears in the display.

[FC-01 ]
Native: 0,01
Foreign: 0,01
FC 0 2 1
4. Use the ┣CASH┫ key to switch to
the foreign currency memory loca-
tion.

[FC-02 ]
Native: 0,01
Foreign: 0,01
5. Use the ┣↑┫ and ┣↓┫ keys to switch
to the [FC-0x ] text
input area.

[FC-02 ]
6. Press the ┣CASH┫ key to confirm
the input.

FC-02
7. Delete the existing text.

8. Enter the new foreign currency
text (see Chapter 6.2).
2x
 then 
U
4x
 then 
US
1x
 then 
USD
9. Conclude text input by pressing
the ┣CASH┫ key.

[USD ]
10. Use the ┣↑┫ and ┣↓┫ keys to move
to the Native: [ ] input area.

Native: 0.01
11. Enter the native currency amount.

Native: 1.35
12. Press the ┣CASH┫ key to confirm
the input.

Save...!!
Please Continue...
- Continued on next page -