Operation Manual
Page 65
ECR 650F _______________________Programming Instruction___________________________________
14. FLASH-PROGRAM
You can use this to transfer new firmware to the cash register, exchanging an e-prom is therefore no longer
necessary.
This programme can only be run by a SERD-specialized dealer in the SERD Manager.
1. Pull the mains cable
2. Set the key position on the cash register to “S”
3. Plug in the mains cable.
4. On DISPLAY : Date-- Time-- actuell Firmwareversion
LOAD FLASH MEMORY
FACTORY TEST
EXIBITION
5. With the Keys
[3$*(83] and [5(&(,372Q2))]
go to LOAD FLASH MEMORY and confirm with the
[&$6+] Key.
6. With the Keys
[3DJH83] and [5(&(,372Q2))]
go to OPEN PORTS FOR PC and confirm with the
[&$6+] Key.
7. On Dislay : PORTS READY FOR RECEIVE / SEND, the cash register
is now ready to receive new software.
8. Now start the SERD - Manager on your PC
9. Open either an already available or new file
10. Open the folder Flash Programming
11. Open the folder download a new firmware and activate “Send Firmware to the ECR“. Wait until the data
is saved in the new MOT file (Firmware) and activate it. Follow the instructions on the screen, the new
firmware is loaded and sent automatically to the cash register.
12. End the PC mode on the cash register by pressing the
[=:] key twice, pulling the mains cable, turning
the cash register to “REG“ and plugging the mains cable back in. The programmed data on the cash register
is retained.