Operation Manual

Installing the batteries
• The OLYMPIA MEMO 66 digital recorder
uses two 1.5 V AAA alkaline batteries.
Insert batteries:
• Open the battery compartment by sli-
ding the battery compartment cover on
the back of the recorder in the directi-
on of the arrow.
• Place the batteries into the compart-
ment, making sure they are inserted
according to the correct polarity.
• Slide the battery compartment cover
back on until it clicks into place.
Replacing the batteries
• The remaining battery indicator shows
the battery consumption as follows:
Full ––––––––––––––––––– Empty
• If the battery mark flashes, replace the
new batteries immediately.
Turning the recorder on
To turn the recorder on, simply press the
On/Rec switch on the front. The recorder
switches itself off automatically if it
is not operated for about two minutes.-
The LCD
The LCD provides various information
about the status of the recorder.
When the recorder is switched on, the
initial display shows the record mode
that is selected
SP - standard play
EP - extended play or
LP - long play
in the top left corner.
In the top right corner you can see the
two-digit index number of the message
(00 if no messages are recorded or if you
are using the recorder for the first time).
Underneath the record mode is a display
of the battery status. At the bottom of
the display, you can see the duration of
the selected message.
The bar at the very bottom of the display
corresponds to the scale marked 0 -
100% underneath the LCD and shows
the size of the available memory.
16
17