Operation Manual

6.3 Using F codes
6
6-27
Fax Transmission/Reception Methods Chapter 6
Specifying F codes
When sending faxes
F codes can be specified when the 10-Key Pad is being used to enter the fax
number of a recipient while sending a fax.
1 Using the 10-Key Pad, enter the
fax number of the recipient.
2 Press the [▼] key, and then use
the 10-Key Pad to enter the SUB.
H A number up to 20 digits long
can be entered for the SUB.
H To enter an SID, continue with
step 3.
H If an SID will not be entered, continue with step 4.
3 Press the [▼] key, and then use
the 10-Key Pad to enter the SID.
H A number up to 20 digits long
can be entered for the SID.
4 Press the [Start] key to begin scanning and sending the fax.
Programming F codes
F codes can be specified when programming one-touch dial keys or speed dial
numbers.
For details on programming F codes, refer to “Setting Up the Fax Registration” on
page 7-33 in “7 Using the Utility Mode”.