Quick Start Guide

Protect 6571 Wireless Alarm System

For detailed information, please refer to the operating manuals of the respective compo

nents.

Scope of Delivery

Outdoor siren 1

Power adapter plug 1

Telephone connection cable 1

Remote control 1

Door/Window contacts 4

Wireless motion detector 2

Batteries 11x alkaline AAA

6x alkaline AA

1 x lithium CR2430 3 V

Assembly material Screws, dowels, adhesive tape

Instruction manual 1

Please check the contents of the package carefully. If anything is missing or has been

damaged during transport, DO NOT put the wireless alarm system into operation! In such

cases, contact your sales outlet, with your purchase receipt to hand, or the OLYMPIA

service centre.

NOTE: Keep the packaging in a safe place to protect the equip

ment from damage should it need to be dispatched in

future.

Connecting the Base Unit

Insert three AAA batteries in the battery compartment (pay attention to correct polarity).

Connect the base unit to the telephone and power supply sockets.

RJ11

connector

TAE

connector

Power socket

Telephone

connection socket

RESET

Power

adapter plug

SOS (Emergency Call) Numbers

Enter the emergency call numbers in the base unit.

Configuration

Configure the alarm system according to your requirements.

PAGE 1
Protect 6571 Wireless Alarm System Protect 6571 Wireless Alarm System Connecting the Base Unit For detailed information, please refer to the operating manuals of the respective compo nents. Insert three AAA batteries in the battery compartment (pay attention to correct polarity). Connect the base unit to the telephone and power supply sockets.
PAGE 2
Protect 6571 Wireless Alarm System Putting the Remote Control into Operation Installing the Wireless Motion Detector Remove the plastic strips from the battery on the rear side. Install the holder for the wireless motion detector at a suitable location.