Operation Manual

Water Leak Detector
G
15
Installation
Recommended Installation Locations
The installation location must be within transmission range of the base unit of
the Protect series alarm system.
• Rooms in which there is a risk of flooding due to equipment which uses or
supplies water (e.g. washing machine), taps (e.g. connection for garden hose),
intrusion of rainwater or facilities which can overflow (e.g. bathtub).
• To prevent overflowing and flooding from equipment containing water, hang the
sensors in the container at the height of the required fill level.
Installation Steps

WARNING!
• Risk of serious injuries through damaging cables or lines!
 During installation, pay attention to the possibility of cables running in
the walls. We are not deemed liable for installation errors. If in doubt, con
tact a specialist!
The optimum distance between the sensor contacts and floor is 1 - 2 mm.
Refer to Fig. 4.
1. Open the water leak detector by pressing the lock downwards in direction of
the arrow and sliding the upper section towards the lock. Refer to Fig. 2.
2. The assembly shell of the water leak detector is fixed in place by means of
double-sided adhesive tape or two screws. (You can use the assembly shell as a
template for positioning the drill holes.) Refer to Fig. 5.
When using double-sided adhesive tape, pay attention that the application
surfaces are free of dust and grease.
3. Slide the upper section of the water leak detector onto the assembly shell until
it snaps in place.
Inserting the Batteries
1. Open the water leak detector by pressing the lock downwards in direction of
the arrow and sliding the upper section towards the lock. Refer to Fig. 2.
2. Insert the AAA batteries in the battery compartment (pay attention to correct
polarity). Refer to Fig. 3.
3. Slide the upper section of the water leak detector onto the assembly shell until
it snaps in place.