Operation Manual

Door/Window Contact

Only assemble the door/window contact in the position and alignment illus

trated in Fig. 4. Otherwise, there is no guarantee that the door/window con

tact will function properly.

1. Open the door/window detector by pressing the lock downwards in direction of

the arrow and sliding the upper section towards the lock. Refer to Fig. 5.

2. The assembly shell of the door/window detector is fixed in place on the door/

window by means of double-sided adhesive tape or two screws. Refer to Fig. 7.

When using double-sided adhesive tape, pay attention that the application

surfaces are free of dust and grease.

3. Insert the AAA batteries in the battery compartment (pay attention to correct

polarity). Refer to Fig. 6.

4. Slide the upper section of the door/window detector onto the assembly shell

until it snaps in place.

5. The magnet unit is comprised of a fixation base, two spacers, a permanent

magnet and a cap. Dismantle the unit into its individual parts by pulling it apart.

Refer to Fig. 8.

6. The fixation base is secured in place by means of double-sided adhesive tape

or two screws. Pay attention to the maximum distance of 5 mm to the door/window

detector. Refer to Fig. 1.

When using double-sided adhesive tape, pay attention that the application

surfaces are free of dust and grease.

7. Screw the permanent magnet firmly to the fixation base. Check the height in

relation to the door/window detector beforehand and use the optionally available

spacers which can be plugged onto the fixation base. Refer to Fig. 8.

8. Place the cap on the permanent magnet.

Registering the Door/Window Contact on the

Alarm System

The door/window contact must be registered on an alarm system from the Protect

series. This can also be used to activate further alarm systems and send alarm

signals via the telephone network.

1. Select the

2. Trigger the sensor by opening the window, for example.

3. When the message Magn. Sens. followed by a number appears in the alarm

system display, registration on the alarm system was successful.

4. Change the entry in the alarm system as necessary.

To configure the alarm system, please refer to the manual related to the

alarm system.

Technical Data

Weight: 38 g

Dimensions (W x H x D): Door/Window detector

15.7 x 106.8 x 22 mm

Magnet unit

11.5 x 48 x 34.5 mm

Frequency: 868 MHz

Batteries 2 x AAA batteries