Operation Manual

Device malfunctions

Problem Cause Remedy

Device does not work Is the mains cable plugged

properly in the socket?

Plug the mains cable into

the socket properly.

Is the switch set to ON? Set the switch to ON.

The lamp Power shines.

Does the motor not start

when paper is fed in?

Push the paper into the in-

feed slot so that it touches

the sensor in the centre.

Device does not work after

lengthy operation or

stops during operation

Was the device in constant

operation for some time?

Is the surface of the device

warm?

Pull out the mains plug

from the socket and allow

the motor to cool down to

room temperature.

Paper jam Have you inserted

more than 6 sheets

(406.2C) / 15 (415.4C)

Has the paper not been

inserted straight in the in-

feed slot?

Push switch REV

to push back the paper.

Release Switch REV

to shred the paper remai-

ning in the cutting unit.

Disposal Notes

This symbol [the crossed-out wheeled bin/PICTURE] means that the

product should be brought to the return and or separate collection sy-

stems available to end-users, when the product has reached the end

of its lifetime.

This symbol applies only to the countries within the EEA (*).

(*) EEA = European Economic Area, which comprises the EU Member

States plus Norway, Iceland, and Liechtenstein.