Use and Care Manual
Olympic Waterguard Clear Wood Sealer
GENERAL DESCRIPTION PRODUCT DATA
RECOMMENDED SUBSTRATES
FEATURES / BENEFITS
Olympic Waterguard Clear Wood Sealer was specifically developed to
provide four-way protection while allowing wood to weather and gray
naturally. Recommended for use on exterior wood decks, fences, sid-
ing, railings, outdoor furniture, and other wood surfaces. May be used
on new wood, pressure-treated wood, weathered wood, and wood
with a weathered, solvent-based, clear or semi-transparent stain.
Decks Railings
Fences Siding
Outdoor Furniture
PRODUCT TYPE: Acrylic Resin
VOLUME SOLIDS: 10% +/- 2%
WEIGHT SOLIDS: 11% +/- 2%
VOC: <100 g/L (0.8 lbs./gal.)
WEIGHT/GALLON: 8.4 lbs. (3.8 kg) +/- 0.2 lbs. (91 g)
COVERAGE: Approximately 250 to 350 sq. ft. (23 to 33 sq. meters) per
gallon (3.78 L) depending upon wood texture. Coverage figures do not
include loss due to surface irregularities and porosity or material loss
due to application method or mixing.
DRYING TIME: Normally dries in 24 hours when applied in optimal tem-
peratures of 50°F (10°C) to 90°F (32°C). Application in high humidity or
in temperatures below 50°F (10°C) may prolong drying time. Allow 24 to
48 hours of drying time before light foot traffic or replacing furniture.
CLEANUP: Clean brushes and tools with warm, soapy water.
DISPOSAL: Contact your local environmental regulatory agency for
guidance on disposal of unused product. Do not pour down a drain or
storm sewer.
FLASH POINT: Over 200ºF (93ºC)
PRODUCT INFORMATION
55260XI Clear
Do not tint.
55260XI
OLYMPIC
®
WATERGUARD
®
55260XI
Waterproofing Clear Sealant
4-Way Protection
- Repels Water
- Provides SUNBLOCK
®
U.V. Protection
- Provides a Mildew Resistant Coating
- Penetrates the Surface for Protection
Easy Water Cleanup
LIMITATIONS OF USE
Apply when no precipitation is expected for 24 hours and when air and
surface temperatures are 35°F to 90°F (2°C to 32°C) and will remain
above 35°F (2°C) for the next 24 hours. If the surface is too hot to touch,
lightly mist the surface using a garden hose to cool the surface before
applicatio. Caution: Avoid direct skin contact with hot surfaces. Avoid
staining in direct sunlight.
While this product provides a mildew resistant coating, growth may still
occur if the substrate is not properly prepared prior to painting and/or if
the substrate is consistently exposed to conditions conducive to mold,
mildew, and algae. Examples of these conditions include, but are not
limited to, under eaves, behind shrubbery and trees, and in areas that
are consistently damp with little to no direct sunlight.
Not recommended for recently painted or sealed surfaces. Do not use
on plastic, rubber, asphalt, tile, vinyl, concrete or any non-porous sur-
face.
FOR EXTERIOR USE ONLY. PROTECT FROM FREEZING.
PACKAGING
1-Gallon (3.78 L)
5-Gallon (18.9 L)
Read Label and Safety Data Sheet prior to use. See other cautions on last page.