User's Manual

3.2 Installation of the ALT-Y0003 wall-mount holder on the wall
23
ALT-Y0003 INSTRUCTION MANUAL
Ch.3
2 Referring to the drawings of Figure 3.1 showing the dimensions and weight of the
ALT-Y0003 wall-mount holder, make sure the strength of the wall surface of the four
installation positions. If the strength is insufficient, add reinforcement.
Figure 3.1
3 If screws or nuts need screwing into a concrete wall, determine the hole positions
based on the dimension drawing above and embed anchor bolts or nuts equivalent to
“6 mm nominal diameter of bolt”. When embedding the bolts into the wall, protrusion
of the bolt from the wall surface should be 10 mm to 15 mm.
PRECAUTION
Securely hold the ALT-Y0003 wall-mount holder and install it so that it will not fall
off. If the ALT-Y0003 wall-mount holder falls off, it may be damaged.
4 Hold the ALT-Y0003 wall-mount holder in the direction as shown in Figure 3.1, align
the holder with the mounting holes, and secure it with screws or nuts. The screw or
nuts to be used for installation should be commercially available and equivalent to
“6 mm nominal diameter of nut or bolt,” which is suited to the material of the wall.
5 Make sure that all nuts or bolts are securely tightened. If any of the nuts or bolts
loosen, tighten them again.
304 mm (12.0 in)
152 mm
(6.0 in)
38 mm
(1.5 in)
26 mm
(1.0 in)
10 mm
(0.4 in)
119 mm
(4.7 in)
204 mm
(8.0 in)
Weight of the ALT-Y0003:
Approx.6.5 kg (When accessories are connected)
Weight of the ALT-Y0003 wall-mount holder:
Approx.1.3 kg
Screw/bolt holes
Diameter: ø 8.0
(4 positions)