Use Instructions
Table Of Contents
- 1 About this manual
- 2 Safety
- 3 Hinweise zum Aufstellen
- 4 Tools and accessories
- 5 Scope of supply
- 6 System diagram
- 7 Trays
- 8 Specifications
- 9 Unboxing
- 10 Mounting of components
- 11 Mounting fluorescence components
- 12 Assembly of the housing for scanner
11 Mounting fluorescence components
2. Use the short CAN bus cable (35cm) to connect the U-FFWR to the VS200
system. Note the plug orientation indicated by the red dot.
3. In case you do not have a U-FFWO connect the terminator to the second
plug at the U-FFWR.
11.2.2 Add or replace filter (U-FFWR)
1. Make sure that the power of the VS200 system is switched off.
2. Remove the backside top panel. See Top panel auf Seite 66.
3. To add or replace a 25mm emission filter in the U-FFWR open the cover of
the filter wheel loosening the knurled head screw.
- 47 -
Instructions for useOLYMPUS VS200 System