Use Instructions
Table Of Contents
- 1 About this manual
- 2 Safety
- 3 Hinweise zum Aufstellen
- 4 Tools and accessories
- 5 Scope of supply
- 6 System diagram
- 7 Trays
- 8 Specifications
- 9 Unboxing
- 10 Mounting of components
- 11 Mounting fluorescence components
- 12 Assembly of the housing for scanner
2. Guide the optional liquid light guide through the hole in the back like
shown in the image below.
3. Place the back panel against the backside of the system and tighten the
four knurled hex screws.
12.4 Top panel
Top panel - first part
The top panel consists of two parts. You have to start with the back part (large
part) of the top panel.
The panel has two quick lock pins (1) in the front and two guiding holes in the
back (2). Additionally there are two grounding connectors (3) where you
have to connect the grounding flags coming from the VS200 frame.
On each side of the VS200 scanner there is a quick lock socket (1) and a small
pin (2) as well as one connector with grounding flag attached (3).
On each side there is the connector (system side) for the grounding flag.
1. Connect the two grounding flags (left and right side) to the top panel.
2. Put the top panel parallel to the scanner.
- 66 -
Instructions for use
12 Assembly of the housing for scanner
OLYMPUS VS200 System