Use Instructions

1 About this manual
1 About this manual
This manual for the VS200 system is for Olympus technicians as well as users of the
VS200 system who have been trained by Olympus. The manual contains important
information on how to operate the VS200 system safely and correctly.
In addition, this manual describes how to unbox and install the system as well as
how to install further components. These tasks must expressly only be performed by
Olympus. As a user you are not allowed to unbox or install the VS200 system by your-
self!
To ensure the safety, obtain optimum performance and to familiarize yourself fully
with the use of this product, study this manual thoroughly before installing this
product, and always keep this manual at hand when operating this product.
Retain this instruction manual in an easily accessible place near the work area for
future reference.
Installing and configuring a liquid dispenser, and upgrading to a VS200
loader are not in the scope of this document. These must only be installed
and adjusted by technical service of Olympus.
1.1 Notes on qualifications
Olympus personnel Instructions for tasks that must only be performed by Olympus
are identified with the following note:
The units described below must be assembled and adjus-
ted by Olympus. If these units are assembled or adjusted
by the customer, the operations are not ensured.
1.2 Intended use
The system is intended to be used for the acquisition of virtual slide images. The sys-
tem is intended to be used for research only.
If the VS200 system is used in a manner not specified by this manual, the safety of
the user may be at risk. In addition, the VS200 system may also be damaged. Always
use the VS200 system according to this instruction manual.
Olympus Soft Imaging Solutions GmbH takes no responsibility for damaged caused
by unintended use.
Foreseeable misuse
The system is not intended to be used for primary diagnosis.
- 7 -
Instructions for useOLYMPUS VS200 System