User Manual

202
Troubleshooting
11
Miscellaneous
Possible cause Corrective action Ref. page
The viewfinder does not turn on.
The monitor is turned on. Press f to turn the viewfinder on. P.51
The monitor does not turn on.
The viewfinder is turned
on.
Press f to turn the monitor on. P.51
The viewfinder or monitor is hard to see.
The diopter is not
adjusted properly.
Adjust the diopter so that the AF target mark
is clearly visible.
P.32
There is condensation
*
inside the camera.
Wait until the camera dries before turning it
on again.
—
The brightness of the
viewfinder or monitor is
not adjusted properly.
Select s in the mode menu tab and adjust
the brightness.
P.161
The monitor is exposed to
direct sunlight.
Block the sunlight with your hand or use the
viewfinder.
—
Vertical lines appear in
the viewfinder or on the
monitor screen during
shooting.
Aiming the camera at a bright subject in
sunlight may cause vertical lines to appear on
the screen. This is not a malfunction.
—
The date recorded with the image data is wrong.
The date/time is not set. Set the date/time. The clock adjustment is not
factory-preset.
P.30
The camera has been left
with the battery removed.
If the camera is left for one day with the
battery removed, the date/time setting is
canceled. Set the date/time again.
P.19, 30
The settings are returned to the factory default settings when the camera is
turned off.
ALL RESET is set to ON. Select the SETUP tab in the mode menu and
set ALL RESET to OFF.
P.147