User Manual
Table Of Contents
- CAMERA OPERATION MANUAL
- How to use this manual
- Composition of the manual
- Contents
- Names of parts
- 1 Getting started
- 2 Using the menus
- 3 Shooting basics
- 4 Flash
- 5 Advanced shooting
- A/S/M mode
- Aperture priority shooting
- Shutter priority shooting
- Manual shooting
- Using My Mode
- Focusing applications
- Metering
- AE LOCK - Locking the exposure
- Macro mode shooting
- Super macro mode shooting
- Self-timer shooting
- Remote control shooting
- Sequential shooting
- PANORAMA - Panorama shooting
- 2 IN 1 - Taking two-in-one pictures
- FUNCTION - Adding special effects to pictures
- Recording sound with still pictures
- Recording sound with movies
- Using commercially available external microphones
- 6 Adjusting the image quality and exposure
- 7 Playback
- 8 Useful functions
- ALL RESET - Saving the camera’s settings
- CUSTOM BUTTON
- SHORT CUT
- MY MODE SETUP
- CARD SETUP - Formatting cards
- Information display
- Monitor/viewfinder brightness adjustment
- REC VIEW
- SLEEP - Sleep Timer
- Beep
- SHUTTER SOUND
- VOLUME - Playback volume
- POWER ON/OFF SETUP - Power on/off display/sound setting
- SCREEN SETUP
- FILE NAME
- PIXEL MAPPING
- Measurement units
- VIDEO OUT - Video output selection
- 9 Print setting (DPOF)
- 10 Direct printing (PictBridge)
- 11 Miscellaneous
- DIGITAL CAMERA - PC CONNECTION OPERATION MANUAL

203
Troubleshooting
11
Miscellaneous
Possible cause Corrective action Ref. page
The picture is out of focus.
The subject was too
close.
Move further away from the subject. To take
pictures closer than 7 cm (2.8") with the zoom
in the maximum WIDE position, use the
super macro mode.
P.90, 91
Auto focus is not
possible.
Use manual focus or focus lock to focus on
the subject and then shoot.
P.83, 54
There is condensation
*
on the lens.
Turn the camera off and wait until it dries
before turning it on again.
—
The monitor goes off.
The camera is in the
sleep mode.
Operate the camera (press the shutter button
or turn the zoom lever).
P.25
The power is turned off
with the monitor off.
If ALL RESET in the mode menu is set to
OFF, the camera settings before the power
was turned off remain unchanged.
Turn on the monitor, and turn off the power.
P.51, 147
* Condensation: When it is cold outside, the water vapor in the air is rapidly cooled
and turns to droplets of water.
Condensation occurs when the camera is suddenly taken from a
cold place into a warm room.