Operation Manual

92
6
Playback
Recording sound
Sound can be added to a still picture that you have already taken. (This is
known as “after-recording”.) You can also re-record over the sound that
has already been recorded. Total recording time per picture is
approximately 4 seconds.
Select the still picture to which you want to add sound.
Top menu [MODE MENU] [PLAY] [R] gMenus” (P.17)
1 Press d to display [START].
2 Aim the camera microphone
toward the sound you want to
record and press e to start
recording.
The [BUSY] bar is displayed during
recording.
Note
If the microphone is farther than 1 m (3.3 ft.) from the subject, sound may not
be recorded properly.
If you re-record the sound, the original sound is erased.
You may not be able to record sound when there is insufficient card memory
(the “CARD FULL” message is displayed).
Sound recording may pick up camera noises, such as button operation or
shutter movement.
Once sound is added to a picture, it is not possible to erase only the sound. In
this case, make a re-recording with silence.
Mode dial
START
EDIT
CARD
SET
PLAY
P
O
W
E
R
W
T
Microphone