Owner manual

9
Connecting the DS-3000 Digital Recorder
The DS-3000 works with both the Dictation Module and the Transcription Module.
Notes
- Make sure you finish installing DSS Player Pro before connecting the DS-3000. If you connect
the DS-3000 before installing DSS Player Pro, the "Add New Hardware Wizard" dialog box will
open. If this happens, click "Cancel" to exit the wizard and install DSS Player Pro (
P.6).
- Before connecting the USB cable to the DS-3000, make sure that theDS-3000 is in the stop
mode, with its rear-panel POWER/LOCK switch ON and that the HOLD switch is not set to the
HOLD position.
1
Insert the USB cable connector A into the
PC USB port.
AB
Insert the USB cable connector B into the DS-3000.
2
DSS Player Pro launches automatically when the software recognizes the DS-3000.
Notes
- For information about your PC's USB ports, refer to the user's guide supplied with the PC.
- Never remove the USB cable while a communication session is in progress. Data files could be
damaged if you do.