Computer Drive User's Manual

2 Inserting a card <98/98 SE/Me

⽧

Operation>

1. Make sure the MAUSB-10 is connected to the computer and insert the card into the corresponding card

slot.

[xD-Picture Card]

Make sure the card is level and that the gold-colored contact area is facing down. Insert the card all the way

into the left-hand slot.

[SmartMedia]

Make sure the card is level and that the gold-colored contact area is facing up. Insert the card all the way

into the right-hand slot.

2. Close the card cover.

MAUSB-10

Notes

• Make sure that the card is facing the right way.

• Do NOT insert the card at an angle. Forcing a card in diagonally may damage the card and/or the

MAUSB-10.

• MAUSB-10 will not be able to recognize the card(s) if the card cover is open.

• The status lamp blinks every two seconds if the card is not recognized correctly. If this happens,

remove the card(s) from the MAUSB-10, wipe the contact area with a dry cloth, and insert the card(s)

again. If the problem persists, the card may be damaged.

Card slot

(for xD-Picture Card)

Status lamp

(green)

Card cover

Contact area

Card slot

(for SmartMedia)

[Status lamp]

Lights when a card is inserted and the card cover is closed.

Blinks when a card is being read or written to.

* Do not open the card cover or disconnect the USB cable when the status

lamp is blinking. Doing so may destroy the data stored on the card.

Inserting the cards

xD-Picture

Card

SmartMedia