Installation Instructions

How to Attach Anti-Furl Rings

• Slide top and bottom ring onto pole – bottom ring has screw at bottom; top ring has screw on

top. Spring clips now should be facing each other.

• Use the spring clip to attach grommet of flag or tab inside sleeve. Use the screw to tighten

snugly against pole. Make sure screw is on outside of pole.

• Lay out flag next to pole to locate placement of top and bottom rings on flag with grommets.

• Leave a little slack in the flag header between top and bottom rings.

If flag is stretched too tight, flag will not unfurl properly.

Each flag is individually sewn, and slight adjustments may have to be made.

PAGE 1
How to Attach Anti-Furl Rings • Slide top and bottom ring onto pole – bottom ring has screw at bottom; top ring has screw on top. Spring clips now should be facing each other. • Use the spring clip to attach grommet of flag or tab inside sleeve. Use the screw to tighten snugly against pole. Make sure screw is on outside of pole. • Lay out flag next to pole to locate placement of top and bottom rings on flag with grommets. • Leave a little slack in the flag header between top and bottom rings.