Installation Instructions

How to Assemble and Install 6’ Spinning Flagpole

Contents:

• 6 ft. brushed aluminum flagpole, 2 sections, 1 in dia.

• Silver ball ornament

• Two flag rings with screw anchors, one flag clip at top for use with sleeved flags

Assemble Pole:

Slide and screw top section into bottom pole section. Top pole has ball bearing assembly and will rotate.

Attach Flag:

Flag with grommets – Slide rings onto flagpole. Lay out flag on top of pole and position flag rings on pole

where grommets are located on flag. Align grommet over hole in flag ring and insert screw and tighten to

secure flag to ring. Note: if your flag has grommets that are too large and slide over the screw head,

consider using a nylon or plastic washer over the grommet before inserting screw to adjust for the difference.

Flag/Banner with sleeve – Using the flag hook under the ball ornament, press hook to open and attach to

opening in tab sewn inside banner sleeve.

Insert pole into proper size bracket (purchased separately) to fly your flag proudly.

For best results, remember to take flag set down during periods of rain, winds and other inclement weather

to help prolong life.

PAGE 1
How to Assemble and Install 6’ Spinning Flagpole Contents: • 6 ft. brushed aluminum flagpole, 2 sections, 1 in dia. • Silver ball ornament • Two flag rings with screw anchors, one flag clip at top for use with sleeved flags Assemble Pole: Slide and screw top section into bottom pole section. Top pole has ball bearing assembly and will rotate. Attach Flag: Flag with grommets – Slide rings onto flagpole. Lay out flag on top of pole and position flag rings on pole where grommets are located on flag.