Installation Instructions

App.
EMC information
97
SC-1 INSTRUCTION MANUAL
 Guidance and manufacturer’s declaration — Cables used for
EMC compliance testing
This model has passed the EMC compliance testing with the cables below.
Refer to the instruction manuals for each piece of equipment.
 FCC Note (for the USA)
Any changes or modifications not expressly approved by the grantee of this device could void the
user's authority to operate the equipment.
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
End-users and installers must be provided with antenna installation instructions and transmitter
operating conditions for satisfying RF exposure compliance.
For product available in the USA/Canada market, only channel 1 – 11 can be operated. Selection of
other channels is not possible.
 IC Note (for Canada)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de.
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
Cet appareil et son antenne (s) ne doivent pas être situés ou fonctionner en conjonction avec une
autre antenne ou émetteur.
Product
Name
Description
Cable
(Shield)
Length
[m]
Location
Classificatio
n
Test Included
MAJ-1918 USB cable Yes 1.8
Bottom of the
cradle (USB1
terminal)
SIP/SOP
Emission/
Immunity
– LAN cable No 3
Bottom of the
cradle
SIP/SOP
Emission/
Immunity
– HDMI cable Yes 3
Side panel of
the tablet
SIP/SOP
Emission/
Immunity