Owner's manual

SZX7

OPERATION

4-1 Stand

Using the Stage

1. When reflected light illumination is used, the stage plate can be placed

either the white or black surface facing up depending on the specimen.

However, when the ESD performance is required, always use the black

surface of the stage plate.

2. When transmitted light illumination is used, use the transparent glass

stage plate (SP-C).

Adjusting the Focus Adjustment Knob Tension

(Fig. 1)

}This operation is intended to facilitate the rotation of the knobs while

preventing spontaneous drop of the microscope body. It is recommended

to set the knob tension to a slightly higher level than the point where

spontaneous drop occurs.

1. Hold the left and right focus adjustment knobs @ with both hands, fix the

left knob and rotate the right knob. The rotation tension of the knobs

increases or decreases according to the direction in which the right knob

is rotated.

2. If the rotation tension is increased too much, accurate focusing is not

possible and the mechanism may be damaged.

4-2 Observation Tube

Adjusting the Interpupillary Distance

(Fig. 2)

#Always hold the eyepiece sleeves @ with both hands when adjust-

ing the interpupillary distance.

While holding the left and right eyepiece sleeves @ with both hands,

look through the eyepieces and adjust for binocular vision until the left

and right fields of view coincide completely.

Fig. 1

Fig. 2

To decrease

To increase

Clamp.