User Manual

68 EN 68 EN
For the operation method, refer to (P. 50).
 G. Field Sensor
Entering the altitude/depth for the current location
H [Elevation / Depth]
1 Use FG (arrow pad) to choose a value.
• To use different units, proceed to Step 2. To proceed without changing
units, press the A button.
2
Press I (arrow pad).
3 Use FG (arrow pad) to choose the units and press the A button.
Recording GPS data with pictures H [Record GPS location]
Submenu 2 Application
Off
GPS data are not recorded with pictures.
On
Record GPS data with pictures.
• If [Off] is selected for [Record GPS location], location data will not be added to
pictures even if the LOG switch is rotated to LOG.
Choosing a GPS mode H [GPS Priority]
Submenu 2 Application
GPS accuracy
Prioritize the accuracy of GPS data over battery endurance.
Battery power
Prioritize battery endurance over data accuracy.
 H. K Utility
Adjusting the image processing function H [Pixel Mapping]
• This function has already been adjusted at factory shipping, and no
adjustment is needed right after purchase. Approximately once a year is
recommended.
• For best results, wait at least one minute after taking or viewing pictures
before performing pixel mapping. If the camera is turned off during pixel
mapping, be sure to perform it again.
To adjust the image processing function
Press the A button when [Start] (Submenu 2) is displayed.
• The check and adjustment of the image processing function starts.