User guide

22
EN
Image size
*4
Sets the number of recording pixels.

4608×3456 Suitable for printing pictures over A3 (11×17 in.).
4
3264×2448 Suitable for printing pictures up to A3 (11×17 in.).
n
2560×1920 Suitable for printing pictures up to A3 (11×17 in.).
3
2048×1536 Suitable for printing pictures up to A4 size (8.5×11 in.).
2
1600×1200 Suitable for printing pictures at A5 (5×7 in.).
1
1280×960 Suitable for printing pictures at postcard size.
7
640×480 Suitable for using pictures on emails.
0
1920×1080 Suitable for playing pictures on a TV (widescreen TV) and for printing on A5 (5×7 in.).
*1
Flash option is limited to [$ Flash Off] when macro option is set to [a Super Macro].
*2
Flash option is limited to [_ Flash Auto], [# Fill In] or [$ Flash Off] when drive setting is set to [j Sequential], or
to [$ Flash Off] when drive setting is set to [c High-Speed1] or [d High-Speed2].
*3
ISO sensitivity is limited to [l ISO Auto] when drive setting is set to [c High-Speed1] or [d High-Speed2].
*4
[Image Size] is limited to [3] or lower when drive setting is set to [c High-Speed1] or [d High-Speed2].
Registering one touch white balance
Registering one touch white balance
Select [

One Touch 1] or [

One Touch 2], face the camera toward a piece of white paper or other white object, and
press the  button.
● The camera releases the shutter and the white balance is registered. When the white balance was previously
registered, the registered data is updated.
● The registered white balance data will not be cleared by turning off the power.
● Perform this procedure under the light where the pictures will be actually taken.
● When the camera settings are changed, the white balance must be registered again.
When the white balance cannot be registered, check that the white paper fi lls the screen, and then perform the
procedure again.