Safety Instructions

21
The “Tube Heating Timer” is visible
on the display. Wait until the
required 180 seconds is complete
before placing the amplifier in
OPERATE Mode.
After heating is completed, the PA will
light the STBY mode indicator and this
Main display will appear.
NOTE: If CAT or ANTENNA settings are
populated the associated windows
will reflect these settings.
Depending on CAT settings you would have two possible situations illustrated. If NO CAT was saved, the
above display will be visible. To manually set band and segment for transmitting, use BAND and SEGMENT
buttons. In this mode exact frequency will be read from RF input and PA will set up on it automatically.
COM. LOST appears if CAT was defined but TCVR is not connected with the PA (CAT cable). See the
following pictures.
FREQ button has two functions. It
allows displaying the working
frequency or active band segment.
NOTE: If CAT is used the working
frequency will be read directly from
the TCVR.
Use ANTENNA (left/right) to select
one of the preprogramed antenna for
that band.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.