OPERATION, MAINTENANCE AND SAFETY INSTRUCTIONS FOR OMEGA ALTISE AALTURAS HEATER AALTURASB AALTURASW OMEGA ALTISE
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT: Read the safety precautions of this booklet carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage.
GENERAL HEATER PARTS LCD INDICATORS (MAIN UNIT & REMOTE CONTROL) GETTING STARTED ON Position 1. Carefully remove the heater from the plastic bag and the carton. OFF Position 2. Place the heater on a stable and flat surface. 3. Set the main power switch to the ’OFF’ position (see diagram on above right). Plug the cord set into a 220-240V~A.C. 50Hz earthed electrical outlet. Turn the main POWER switch to the ’ON’ position.
FUNCTION SETTING The heater may be operated by the manual controls located on the heater (refer to the MANUAL OPERATION section) or by your remote control (refer to the REMOTE CONTROL OPERATION section). MANUAL OPERATION 1. TURN THE UNIT ON (POWER): Turn the heater ON by pressing the ‘POWER’ button; the LCD of the unit will display the current ROOM temperature.
LOW HEAT MODE - The heating element is turned on and the unit is operating with the fan at its low setting. The UP and DOWN buttons are also disabled in this mode. HIGH HEAT MODE - The heating element is turned on and the unit is operating with the fan at its high setting. This is also the default operation of the heater. The UP and DOWN buttons are also disabled in this mode. AUTO MODE - This is the only mode where the UP and DOWN buttons are not disabled.
4. WARM A BIGGER SURFACE AREA (OSC - OSCILLATION): Pressing the ‘OSC’ button will allow the heater to oscillate. The heater can oscillate up to 70o. To stop the oscillation, press the ‘OSC’ button once more. (see figure below) OSCILLATION (OSC) INDICATOR - When this symbol is displayed, your unit is in oscillation mode. 5. SET THE SLEEP TIMER (TIMER): The timer function allows you to set the length of operation of your heater from 0.5 hour to 7.5 hours.
SAFETY FEATURES 1. A thermal overload protector is built in to prevent overheating. 2. When an overheat temperature is reached, the heater will automatically shut off. It can only resume operation when the user resets the unit (see reset instructions below). 3. If the unit is tilted, a safety system automatically will cut off the power, put the unit in a vertical position and it will go on stand-by mode. Turn the unit on by pressing the POWER button and the unit will start operating again as per normal.
A division of Shriro Australia Pty Ltd 104 Vanessa St Kingsgrove NSW 2208 In Australia: 1300 795 572 In New Zealand: (09) 415 6000 www.omegaaltise.