OAPC187 PORTABLE AIR CONDITIONER
Table of Contents Table of Contents ......................................................................... 2 Important Safeguards ................................................................... 3-4 Placement and Installation............................................................ 5-6 Parts List ....................................................................................... 6-7 Control Panel ................................................................................ 8 Remote Control .
Important Safeguards Please read this manual Inside you will find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventative care on your part can save you a great deal of time and money over the life of your air conditioner. You will find many answers to common problems inside this manual.
• Always contact an authorized qualified service agent to carry out repairs. • If the supply cord is damaged it must be repaired by a qualified repairer • Keep the area clear around the air conditioner. There needs to be an air path of a Minimum of 50cm all around the air conditioner from walls, furniture and curtains. • If the air conditioner is knocked over during use turn off the air conditioner and unplug it from the power point.
Placement and Installation Placement Place the on flat and dry ground, and keep at least 50 cm from walls etc. (figure 1) Installation • Spin slide bar connector into exhaust hose first, then spin the exhaust hose into exhaust connector (counter-clockwise). • Put slide bar connector into adjustable slide bar, adjust window open width in order slide bar match window well, and the length of slide bar is adjustable.
FIGURE 2 FIGURE 3 Warning Use only the exhaust pipe supplied.
Parts List 7
Control Panel Operation 1. POWER: press this key to turn air conditioner On or Off. After air conditioner turns on, default value is Auto mode with medium fan speed. 2. OPERATION MODE BUTTON: after air conditioner turns on, for auto mode, press this key to select the other modes: Fan, Dry/dehumidify, Cool or Auto. 3. FAN SPEED: after air conditioner turns on, press this key to select between 3 fan speeds (high, medium or low). 4.
Remote Control Operation Methods Auto Mode According to the current room temperature, once you select AUTO it automatically selects the relevant mode. Cooling Mode • After air conditioner turns on, the air conditioner will revert to setting that was last used. • Press “OPERATING MODE BUTTON”” to select cooling mode, once this option is selected cooling mode inductor turns on. • Press “UP” or “DOWN” to adjust temperature (from 16 • Press “FAN Speed Button” to select high, Medium or low fan speeds.
Timer Mode • When in off/ standby, press "TIMER" to setup the power-on timer, press "UP or "DOWN" to adjust the timer (from 1-24 hours) press "TIMER" to confirm selection. • "Under power-on mode, press "TIMER" to setup power-off, Press "UP or "DOWN" to adjust the timer (from 1-24 hours) press "TIMER" to confirm selection Dry/ Dehumidifying Mode • Press “OPERATING MODE BUTTON” to select dehumidifying mode, once this option is selected dehumidifying mode indicator turns on.
Water Drainage This air conditioner has an auto-water-evaporating system. Condensedwater cycle is used to cool down the condenser, which not only improves cooling efficiency, but also saves energy. If inner water tank is full, ”W.F” indicator will light on the screen, after 5 minutes the compressor stops working.
Maintenance Note: in order to avoid electric shocks, please turn off at the control panel, switch off the power point then unplug the air conditioner before cleaning Cleaning • Please switch off at the control panel, then at the power point then unplug before cleaning. • Use soft semi-dry cloth to clean the air conditioner. Don’t use chemical agents, such as benzene, alcohol, gasoline etc.; otherwise the air conditioner surface can be damaged.
Seasonal Cleaning If the air conditioner is not being used for a long time, please follow these steps. • Pull out drainage plug upper / lower to empty any water out. • Let the air conditioner run under fan mode for 2 hours to dry out the air conditioner internals • Turn off the air conditioner, switch off the power point and remove the plug. • Clean and dry filters then reinstall them. • Pull out exhaust pipe for safe keeping.
Technical Data Model OAPC187 BTU/h 18000 Power consumption W 2000 Current A 9.3 Cooling capacity Mains Refrigerant R410A Compressor Rotary Fan speeds 3 Thermostat ℃ Timer h Dimensions(W*H*D) Gross Weight 16-31 mm 0-24 47 x 76.
Appendix A Circuit Diagram
Omega Altise air conditioners are distributed in Australia by Shriro Australia Pty Ltd. Locked Bag 5002, Kingsgrove NSW 2208 Phone: 1300 795 572 Fax: (02) 9415 5525 Web: http://www.omegaaltise.com.