OP40B 40CM BLACK PEDESTAL FAN
TABLE OF CONTENTS Important Safety Instructions. ........................................................................................1 Technical Details and Parts. .......................................................................................... 2 Getting Started. ............................................................................................................. 2 Appliance Components.................................................................................................
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT: Read the safety precautions of this booklet carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage.
TECHNICAL DETAILS AND PARTS Model: OP40B Black Pedestal fan Power: 220-240V 50Hz, 60W. Gross Weight: 14.5kg. Dimensions 130–170 H(max) x 45.5 W x 45.5 D cm 1. Carefully remove the parts of the appliance from the plastic bags and the carton, and unwind the cord to its full length. 2. Place the weight of the base under the base and insert the lower tube through the holes of them. Fix the parts together by using the nut provided. 3. Connect the middle tube to the lower tube by screwing them together. 4.
APPLIANCE COMPONENTS 1 7 6 8 2 3 4 5 9 11 1. Grid 2. Blades 3. Upper tube 4. Middle tube 5. Lower tube 6. Motor 10 7. Off/Speed control knob 8. Blue LED rotary controller 9. Base 10. Weight for the base 11.
ASSEMBLY Unpack the fan and make sure all the parts are available before you proceed with the installation. 1 Place the weight of the base (10) under the base (9) and insert the lower tube (5) through the holes of them. Fix the parts together by using the nut provided. 2 Connect the middle tube (4) to the lower tube (5) by screwing them together. 3 Connect the upper tube (3) to the middle tube (4) by screwing them together. The upper tube has 2 holes on the top.
4 Insert the power cord (11) through the base (9), the bottom tube, the middle tube and the upper tube. The connector of the power cord should come of the upper tube. 5 Link the connector coming out from the upper tube (3)to the connector coming out from the head (6) of the fan and fix them by rotating the plastic nut.
6 Fix the head (6) of the fan to the upper tube (3) by using the 2 screws provided. 7 Fix the power cord (11) under the base (9) by using the cable holder and the 2 screws provided.
N.B: 170 cm 130 cm The fan can be installed at two heights depending on whether or not the middle tube is used. If the smaller size is needed please avoid the steps 2 and 3 of assembly and proceed to connect the upper tube to the lower tube by screwing them together. ATTENTION: do not connect the fan to electrical supply until the unit is fully assembled.
HOW TO USE Place the fan in a flat and stable surface. Make sure the Off/Speed knob is in Off position (“0”) then plug it into a correct socket. To select the desired speed rotate the Off/Speed knob; the desired speed must be aligned at the reference dot place on the motor.
