Specification Sheet

REVISED – March 25, 2006 submitom.doc (9/23/03)

ALUMINUM REFLECTOR

 Bright Finish 304 Stainless Steel Reflector

 High Reflectivity

 Used With Omega II

Radiant Tube System

 Corrosion Resistant

SPECIFICATIONS

CRC Part No.:

0360.02 - 10’-0” Long

Wt. – 5.0 Lbs. (2.27 kg)

Dimensions:

Minimum 0.025” Thick Bright Stainless Steel,

10’-0” Long.

INSTALLATION & CHECKOUT

INSTALLATION

Install reflectors over radiant tubes as shown on shop

drawing. Note, secure reflectors together at each

straight run allowing for one unsecured joint for

expansion - Refer to the owner's manual for

installation guidance.

Checkout

Make sure that the radiant tubes and reflectors are

installed in accordance with the owner’s manual as

well as the shop drawing. Inspect to make sure that all

radiant tubes are connected square and straight.

Make sure that one expansion joint for each straight

run is installed

COMBUSTION

RESEARCH

CORPORATION

Part No. 0360.02, Reflecto

Stainless Steel Reflecto