User Manual

Omega II
®
Installation, Operation & Service
Combustion Research Corporation
INSTALLER
PLEASE TAKE TIME TO READ AND UNDERSTAND THESE INSTRUCTIONS PRIOR TO
ANY INSTALLATION. Contact your representative or the factory if you have any questions
OWNER
Retain this manual in a safe place to provide your
serviceman with information if the situation arises.
TABLE OF CONTENTS
PAGE(S)
Heater Safety & Burner Label Placement 1 & 2
Warning Symbols 3
Standards, Certifications and Codes 3 & 4
Installer Qualifications & Responsibility 4
Assembly – Tube and Reflectors 5 - 7
Suspension Methods 8
Combustion Tube Installation 9
Reflector Mounting 9
Customizing System 9
Seismic Restraint Suspension 10
Burner Connection & Installation 11
Gas Supply 12
Flexible gas Connector Installation 13
Technical Data 14
System Dimensions 15
Clearance To Combustibles 16 & 17
Side Shield Installation 18
Combustion Air 19 & 20
Venting 22 – 24
Electrical Information 25
Thermostat Wiring 27
System Start-Up 28 & 29
Sequence Of Operation 29
Service & Maintenance 29 – 33
Trouble Shooting Flow Chart 34 & 35
Burner Parts List 36 & 37
Accessories & Optional Equipment 38 – 40
Warranty Statement and Terms and Conditions 41 & 42
Sample Clearance To Combustible Warning Sign 43
Omega II
®
heating systems DO NOT qualify for use in explosion proof installations.
Heaters SHALL NOT be used in living/sleeping areas.
2016 COMBUSTION RESEARCH CORPORATION, INC.
All rights reserved. No part of this work covered by the copyrights hereon in may be reproduced or copied in any
form or by any means - graphic, electronic, or mechanical, including photocopying, recording, taping, or
information storage and retrieval systems - without written permission of COMBUSTION RESEARCH
CORPORATION, Inc.