Omega National FEEDLOT CTS Floating Shelf 2-ct #6 x Screw Metal Bracket Floating Shelf Floating Shelf Includes: 1-ct Floating Shelf 1-ct Wood Mounting Plate 2-ct Metal Bracket 4-ct #10 x 3-in Washer Head Screws 4-ct #8 x Truss Head Screws 2-ct » #6 x Flat Head Screws Important Notes + Always read the instructions completely and carefully before beginning assembly. « Remove and check contents for damage and for missing pairs.
Step 1: Mark a level line, the length of the Wood Mounting Plate, on the wall down from where the top of the shelf is to be located. Step 2: Along the line locate the location of the wood studs behind the wall and mark the center line of the studs on the line. Hold the Ward Mounting Plate on the wall in the desired location and transfer the stud center lines to the Wood Mounting Pilate. Note: If 2 studs are not available for mounting the shelf, bracing between studs should be added.
~, Step T: You can now install the Floating Shelf on to the Metal ‘Bracket and Wood Mounting Plate assembly pushing it back against the wall. This will be a snug fit but should not be forced if Metal Brackets are aligned correctly. ETS > : FIG. 07 Step 8: When you are satisfied that the Floating Shelf is located correctly, screw or pin the Floating Shelf to the Wood Mounting Plate as shown.
i Omega Nacional PRODUCTOS Estante Flotante ! ! placa de montaje de 2 unidades: tornillos de madera cabeza plana pulga 4 unidades: tornillos con cabeza de arandela #10 x 3 pulga bo 4 unidades: tornillos con cabeza en cruz pulga 2 unidades: abrazadera de metal estante flotante El estante flotante incluye: 1 unidad: estante flotante 1 unidad: placa de montaje de madera 2 unidades: abrazadera de metal 4 unidades: tornillos con cabeza de arandela #10 x 3 pulga 4 unidades: tornillos con cabeza en cruz #8 x 3/4 p
Paso 1: Marque una linea de nivel, la longitud de la placa de -~ montaje de madera, en la pared 9,52 mm por debajo de donde se colocara el estante superior. Paso 2: Alo largo de Ia linea, ubique donde están los montantes de madera detrás de la pared y marque la linea central de ellos en la linea. Sostenga la placa de montaje de madera en la pared en el lugar que desee y transfiera las |lineas centrales del montante a dicha placa.
Paso 7: Ahora puede instalar el estante flotante en el i. ensamblaje de las abrazaderas de metal y la placa de montaje de madera. Para hacerlo, empuje el estante contra la pared. Asi quedara ajustado y no debe forzaras si las abrazaderas de metal están alineadas correctamente. Paso 8: Cuando considere que el estante flotante esta colocado correctamente, atornille el estante flotante a la placa de montaje de madera como se muestra.