Setting up the HandyPort The OM-SQ-RF-ADAP Handyport Wireless adaptor provides wireless communications via the data logger’s serial port. The OM-SQ-RF-ADAP HandyPort has a factory default of 9600 Baud. To use from the box you will need to change the OMEGALOG® serial baud rate to 9600 (the OMSQ2010/SQ2020/SQ2040 series data loggers normally communicates at 115k baud). See Modifying RS232 Baud Rates in OMEGALOG® Help to change the baud rate.
Push the RST button of the Handyport if it is communicating correctly the link LED (on the Handyport) will start to flash every second press the Enter Key after 5 seconds. Type ‘B’ and press the Enter Key. Type ‘7’ (for the baud rate 115200) and press the Enter Key.
Type ‘X’ (to save the setup) the press the Enter Key. Repeat the procedure with the second Handyport. Exit the Hyper Terminal program.
Using the Handyport Connect the Handyport to the RS232 Serial Com port of the PC with a 9-pin standard serial cable and connect the power supply (USB lead or separate power pack). Connect the second Handyport to the data logger with a null modem serial cable LC75 then connect the power supply (this could be from the same power pack as used with the data logger or a separate power pack). The green LINK led will come on when the contact between the Handyports has been established.
