- OMEGA Monitor Manual

3
CONTENTS
Chapter 1 Chapter 2 Chapter 3 Chapter 4 Chapter 5 Chapter 6 Chapter 7
INDEX
APPENDIX
2.4 Escape Sequence......................................................................................................................... 2-13
2.4.1 Execution of Trigger ..................................................................................................... 2-13
2.4.2 Status Output ................................................................................................................. 2-13
2.4.3 Open Command ............................................................................................................ 2-14
2.4.4 Close Command ............................................................................................................ 2-14
Chapter 3 TRANSMITTING FUNCTIONS
3.1 Introduction to Output Data Formats............................................................................................ 3-1
3.1.1 TS0 .................................................................................................................................. 3-1
3.1.2 TS1 and TS2 ................................................................................................................... 3-1
3.2 Output Data Formats .................................................................................................................... 3-2
3.2.1 Output Format of Measured Values in ASCII Mode ...................................................... 3-2
3.2.2 Output Format of Measured Values in Binary Mode ..................................................... 3-3
3.2.3 Output Format of Parameter Settings ............................................................................. 3-4
3.2.4 Output Format of Unit and Decimal Point Information.................................................. 3-5
Chapter 4 TIME CHART
Chapter 5 INITIAL STATUS
Chapter 6 ERRORS DURING RS-422-A OUTPUT
6.1 Preventing Errors .......................................................................................................................... 6-1
6.2 How to Request Error Message Output ........................................................................................ 6-2
6.3 Timing of Resetting the Error Status ............................................................................................ 6-3
Chapter 7 PROGRAM EXAMPLES
7.1 Program to Read Parameter Settings from VR200, Display Them
on Screen and Write Them to Disk .............................................................................................. 7-1
7.2 Program to Read Parameter Setting from Disk, Display Them
on Screen, and Set up VR200 ....................................................................................................... 7-2
7.3 Program to Read Unit and Decimal Point Information from R200,
Display It on Screen, and Write It to Disk ................................................................................... 7-3
7.4 Program to Output Measured Data (in ASCII Code) from VR200 and
Write to Disk ................................................................................................................................ 7-4
7.5 Program to Output Measured Data (in Binary Code) from VR200 and
Write to Disk ................................................................................................................................ 7-5
APPENDIX
Appendix 1 ASCII Code Table ..................................................................................................... App-1
Appendix 2 File Naming Rules ..................................................................................................... App-2
INDEX