Product Manual

3
Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack.
The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures before
attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills
and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use of
this jack is authorized. If any doubt exists as to the safe and proper use of this jack, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by an Omega authorized service center. It is recommended that an annual
inspection be done by qualified personnel and that any missing or damaged parts, decals, warning/safety label or signs
be replaced with Omega replacements parts only. Labels and Operator's Manuals are available from manufacturer (see
Replacement Parts, pages 6 & 7).
PRODUCT DESCRIPTION
Omega Hydraulic Telescopic Transmission Jacks are designed to be used as an aid in the removal and installation of
automotive and light truck transmissions, transfer cases and transaxles. They are intended for use under an overhead
lift or in a garage pit. The air actuated function is an added feature on Model 42001. For Model 42001, ensure that your
air source can dedicate 7.8 CFM @ 90 - 175 PSI. To ensure dependable, trouble free operation an inline air dryer and
oiler is recommended.
CAUTION: READ CAREFULLY BEFORE UNPACKING PRODUCT.
SPECIFICATIONS
Model Capacity
Min.
Height
Max.
Height
Min. Saddle Area Max. Saddle Area Base Size
42001 2000 lb. 48 5/8 77 3/8 15 1/2" x 12 5/8" 24 1/2" x 18 7/8" 42 1/8" x 39 1/2"
42003 2000 lb. 48 5/8 77 3/8 15 1/2" x 12 5/8" 24 1/2" x 18 7/8" 42 1/8" x 39 1/2"
Figure 1 - Model 42001 Nomenclature
Note: Vent Screw and Oil Filler Screw are located on the upper portion of the reservoir.
Air Pump
Saddle
Assembly
Lift pedal
Position Handle
Oil Filler Screw
(not shown)
Base Halves
Swivel Caster
Reservoir
Tilt Adjustment
Knobs
Air Pump Pedal
Release Valve
Air Supply Inlet
(not shown)
Release Valve
Lift Pedal
Saddle
Assembly
Tilt Adjustment
Knobs
Position Handle
Oil Filler Screw
(not shown)
Swivel Caster
Base Halves
Reservoir
Chain
Figure 2 - Model 42003 Nomenclature
Chain
Support Bar
Bracket
Support Bar
Bracket