User's Manual

40
18 = Ni120
19 = OHM
20 = 22 mV
21 = 100 mV
22 = 1000 mV
23 = 10 V
24 = 20 mA
25 = X scaling
Lin (name).AND.80hex = 0 = value OK
80hex = error
if line (name).AND.80hex = 80hex 0 = under
corresponding "Value Lo" 1 = over
2 = error 7
3 = error 2
4 = error 6
6 = error 0
if line (name).AND.80hex = 0
value (name) = 2nd complement (16 bit) Value Hi (name).256 + Value Lo (name)
Mode = 0 = one ramp dual slope
1 = multi ramp dual slope
2 = one step one slope
3 = multi ramp one slope
Type X 0 = 0 - 100 mV
1 = 0 - 1000 mV
3 = 4 - 20 mA
4 = 0 - 400 _
5 = 1 - 5 V
6 = 0 - 10 V
Mode X 0 = linear
1 = square
STO Group selected 0 = A
1= B
2= C
... = ...
n (max. 19) = n (max. T)
Program 0 = Program 1
1 = Program 2
... = ...
n (max. 7) = n (max. Program 7)
Ramp 0 = Autoramp 1
1 = Autoramp 2
2= Program
From........To........ 0 = STO 0 Group A
1 = STO 1 Group A
2 = STO 2 Group A
3 = STO 0 Group B
... = ...
n (max. 59) = STO n Group n (max. STO 2 Group T)
Volt Vbat = (Vbat x 2) / 51
CHKSUM ( checksum ) = DATA1 + DATA2 + DATA3 + DATA4).AND. FF
The above is useful to verify the integrity of transmitted and received data
The minimum time-out of the
CL526
is 5 seconds.
10.5 Computer request for CL526 settings
Computer CL526
Tx IDNAME
_
Rx IDNAME Proceed if name acknoledged
Rx IDNAME
ß
Tx IDNAME If not, do not answer
Tx Instruction
_
Rx Instruction
Rx Instruction
ß
Tx Instruction
Tx DATA 1
_
Rx DATA 1
Rx char
ß
Tx char
Tx DATA 2
_
Rx DATA 2
Rx char
ß
Tx char