BL600 SERIES BLENDER
BLENDER SAFETY DANGER Electricity GENERAL Caution DANGER Risk of Electrical Shock DANGER Keep Hands Clear IMPORTANT: Please adhere to all safety guidelines contained in this manual. DANGER: You can be seriously injured if you do not follow these intructions. WARNING WARNING Electrical Shock Hazard Moving Parts! Always cover the lid on the container when blending. Plug into a grounded outlet. Do not remove ground. Do not put hands, spoons or other utensils in container when blending.
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 14. Screw on locking ring firmly. Injury can result if moving blades accidentally become exposed. 1. Read all the instructions before using the blender. 15. Always operate blender with lid in place. 4. Do not use an adapter. 16. When blending hot liquids, place a hand towel over the cover. Do not fill blender container beyond 2-3 full.
BLENDER OPERATION To operate the blender, proceed as follows 1. For the first time user, wash the container assembly, including the lid, before using it. (Refer to "Cleaning Instruction") Do not put the container assembly & blender base assembly in the dishwasher. 2. Place the blender on a dry, clean, level surface, and press OFF. 3. Place the container onto the blender base. Make sure it rests securely on the base. 4. Plug the blender into an electric outlet. 5. Place the ingredients into the container. 4.
CLEANING INSTRUCTION Omega blender container parts are corrosion resistant, sanitary and easily cleaned. Do not put the container assembly & blender base assembly in the dishwasher. 1.Before first use and after every use, separate container parts from the base. 2.Add cleaning solution to the container. Use washing solution of tepid water (less than 115°F/46°C) and a non-sudsing detergent. Use the recommended amount of detergent. 3.
TROUBLESHOOTING Problem 1. Blender fails to start. 2. Stopped 3. Ingredients do not mix properly Solution 1. Place container properly on the base 2. Check to ensure controls are clean and moving freely. 3. Double-check to ensure power cord is securely plugged into the electric outlet. 4. Check to see if the circuit breaker has tripped or if the fuse for the electric outlet has blown. 4. Check the onboard reset switch located at the rear of the blender base. 1.
MAINTENANCE Inspect the blender and its various parts and replace as follows: Daily Weekly Quarterly 1. Unplug the blender and remove the container from the base. 2. Inspect the container blades for wear, nicks, and broken or loose blades. Replace if necessary. 1. Unplug the blender. 2. Inspect the power cord insulation and power plug for cracks. Refer to "Technical Service" for repair or replacement. 1. Review the condition of the container assembly and Mushroom Clutch Set at least every 90 days. 1.
OMEGA BL600 3 2011 Rev A