manual

1 / 2

CONSTELLATION

DOUBLE EAGLE CO-AXIAL CHRONOGRAPH

Titanium on rubber strap

Caliber

3313

121.92.35.50.01.001

Co-Axial escapement

Automatic

Chronometer

Sapphire crystal

Anti-reﬂective treatment on both sides

Sapphire crystal case back

3-year International Warranty

Water-Resistant to a relative pressure of 10 bar

(100 metres/330 feet)

WATCH FUNCTIONS

The crown has 3 positions:

1. Normal position (wearing position): when the crown is positioned against the

case, the crown ensures that the watch is water-resistant.

Occasional winding: if the watch has not been worn for 44 hours or more, wind it

up with the crown in position 1.

2. Correcting the date: pull the crown out to position 2, turn the crown forwards,

then push the crown back to position 1.

NB: the date cannot be corrected between 8:30 pm and 1 am.

3. Time setting: hours – minutes – seconds. Pull the crown out to position 3. The

seconds hand will stop. Turn the crown forwards or backwards. Synchronise the

seconds by pushing the crown back to position 1 to coincide with a given time

signal.

CHRONOGRAPH FUNCTIONS

• Pusher A: start – stop, start – stop, etc

Timing to 1/8 of a second for up to 12 hours.

• Pusher B: reset (after a stop).

Note: resetting/zeroing of the sub dials must only be carried out after the

chronograph has stopped. Never push the chronograph’s two pushers (A and B)

simultaneously.

PAGE 1
CONSTELLATION DOUBLE EAGLE CO-AXIAL CHRONOGRAPH Titanium on rubber strap Caliber 3313 121.92.35.50.01.001 V Co-Axial escapement l Automatic U Chronometer o Sapphire crystal t Anti-reﬂective treatment on both sides D Sapphire crystal case back G 3-year International Warranty T Water-Resistant to a relative pressure of 10 bar (100 metres/330 feet) WATCH FUNCTIONS The crown has 3 positions: 1.
PAGE 2
FOLDOVER CLASPS Opening (ﬁg. 1): to open the clasp, press the two pushers on either side of the OMEGA buckle and pull upwards. Closing (ﬁg. 2): put the watch on your wrist and close the clasp by pushing on it with your thumb until you hear a click. (ﬁg. 2). Adjusting the length (ﬁg. 3): free the longer section from the two slideways (A) and from the catch (B). Adjust the bracelet in the required direction and reinsert in the catch and the two slideways. Try the watch for size and readjust if necessary.