Owner's manual

4.3.4 Configuration
This section describes the "Configuration" page of the iServers’s Web interface.
Click on , the following page should appear.
When connecting your serial device to the iServer, the Serial Communications
parameters (baud rate, data bit, parity, and stop bit) must be the same on both, the
iServer and your serial device.
Figure 4.12 Configuration
Below are the definitions of terms used in the Configuration Page.
4.3.4.A Serial Communication
Baud Rate: The serial port speed can be set from 300 to 115,200 bits/s (default is 9600
bits/s.)
Data Bit: Options are 7 or 8 (default is 8 bits.)
Parity: Options are Odd, Even, and None (default is None.)
Stop Bits: Options are 1 and 2 bits (default is 1 bit.)
Flow Control: Options are Software Flow Control (Xon/Xoff), Hardware Flow Control
(CTS/RTS), and None (default is None).
CONFIGURATION
CONFIGURATION
http://192.168.1.200
Address
Serial Communication
Remote Access (Tunneling)
Terminal Server
Main Menu
Save Reset
Baud Rate 9600 Data Bit 8 Bits Parity none Stop Bits 1 bit
Flow Control none Transciever RS-232
Modbus/TCP disable
End Char (Hex) 00 Forward End Char enable Timeout 0 msecs
Serial Port Password disable 1234abcd
Connection Ctrl not used
Device No. 1
Connection Timeout 00100 msecs
TCP/UDP TCP Server Type slave Number of Connections 5 Local Port 02000
Remote Access
disable
Remote IP Address 0.0.0.0 Remote Port 02000
Configuration
23
A
B
C