Owner's manual

7
HMG-B Homogenizer Unit
Specifications:
Dimensions:
2.75"W x 9"H x 2.75"D (6.9 x 22.8 x 6.9cm)
Weight:
3.2lb (1.4kg)
Speed range:
10,000 to 30,000 rpm
Wattage:
576W
Voltage:
120v 50/60hz
Current:
4.8 amps (120v)
Sample volume range:
0.03ml to 5L
Noise rating:
72dB
Speed control:
Variable speed, separate on/off switch, digital ready
Certification:
, (120v)
Description:
The HMG-B Homogenizer Unit is a hand-held or optional post-mounted 576 watt homogenizer with variable speed from
10,000 to 30,000 rpm. A separate ON/OFF switch conveniently allows for the speed control dial to remain at your ideal
homogenizing speed. The HMG-B is designed to homogenize, emulsify, blend and mix organic and inorganic materials in
a liquid/liquid, liquid/solid, or solid/solid state.
There is one optional stand available for use with the HMG-B Homogenizer Unit with a small footprint cast aluminum
base. Both stands include a 24" (61cm) vertical support post, heavy duty clamp, and cross rod.
Operating Instructions:
1) Assembly of the homogenizer unit and stand (If using without stand begin with step #2)
a. Screw the cross rod assembly into the threaded hole located in the back of the homogenizer unit.
b. Once the cross rod is threaded into the rear of the homogenizer unit, tighten the jam nut locking the
cross rod in place.
c. Insert the 24" support post into the back of the base and tighten the locking screw.
d. Slide the post clamp down the support post and lock in place.
e. Insert the cross rod and homogenizer unit into the post clamp.
f. Insert end cap onto top of support post.
2) Check that the voltage noted on the back of the motor agrees with the available voltage. Variations of +/- 10%
are permissible.