User's Manual

Figure 3 - DIN 43650 Connector DIN Rail mounting kit IP610-DM
1.4 Pneumatic Connections
1.4.1 Clean all pipe lines to remove dirt and scale before installation.
1.4.2 Supply air must be filtered to 40 microns and free of moisture and lubricants.
1.4.3 The 1/4” NPT inlet and outlet connections are labeled on the body. Plug all unused ports with pipe plugs supplied
with the unit. Avoid getting pipe sealant inside the piping or transducer.
1.5 Electrical Connections
1.5.1 Conduit Connection (current to pressure) Electrical connections are made to the red (+) and black (-) leads. The
green lead is furnished for case ground (see figure 4).
Figure 4
I/P Conduit Connection
Figure 5 - DIN 43650 Connector
Figure 6 - I/P Conduit Connection
1.40
1.29
3
.90
3
.08
1.68
42.7
.
61
1
5.5
D
IN Rail Kit suitable for EN-50035, EN-50045 and EN-50022 Rails
Green Lead (Ground)
Red Lead (+)
Black Lead (-)
Terminal I/P Connection
1 Positive (+)
2
Negative (-)
3 Unused
Ground (+)
1
2
3
Page 4