INSTRUCTION MANUAL Eat well, drink well and live well with Omega www.omegajuicers.com VRT400 SERIES Product Contents OMEGA PRODUCTS, INC. 6291 LYSTER LANE HARRISBURG, PA 17111-4523 U.S.A. PHONE: 1.800.633.3401 FAX: 717.561.
IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS Please read carefully before using. Follow instructions to avoid injury. Additional usage precautions: • To protect against risk of electrical shock or fire, do not put motor base, cord, or plug in water and keep them dry at all times. • Do not pre-operate before inputting food. Doing so may cause a normal squeaking noise. • Do not disassemble the base. All repairs should be made only by authorized personnel.
Omega Juicer Manual For Household Use (Warranty Included) 1. Read “Precautions for safe use (Page 4)” carefully and use the appliance properly. 2. Save these instructions. 3. Check if the voltage indicated on the base of the appliance corresponds to the local voltage before you connect the appliance.
GENERAL DESCRIPTION AND PARTS NAMES SPECIFIC TERMS FOR PARTS HOPPER PULP CONTAINER SQUEEZING SCREW JUICE CONTAINER COARSE STRAINER (OPTIONAL) 1. Hopper front triangle 2. Bowl triangle 4. Hopper rear part 5. Operating switch 3. Pulp outlet 6. Juice outlet 7. Juice cap 8. Power cord FINE STRAINER CLEANING BRUSH SPINNING BRUSH 9.
PRECAUTIONS FOR SAFE USE WARNING Hazards or unsafe practices which could result in serious personal injury or death. CAUTION WARNINGS AND CAUTIONS WARNING Hazards or unsafe practices which could result in serious personal injury or death. Hazards or unsafe practices which could result in minor personal injury or appliance damage. DO NOT PLUG IN OR UNPLUG WITH WET HANDS. It may cause an electric shock or an injury. DO NOT USE WITH OTHER THAN RATED VOLTAGE.
WARNINGS AND CAUTIONS NEVER DISASSEMBLE BOWL SET DURING OPERATION OR INSERT FINGERS, FOREIGN OBJECTS SUCH AS FORKS, SPOONS ETC. INTO FEEDING TUBE OR JUICE OUTLET. It may cause an injury, an accident or a failure. THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
SLOW JUICER ASSEMBLY SLOW JUICER ASSEMBLY IN DETAIL the hopper rear part with base completely as in below. 4 Align The hopper will not close properly when the parts are not assembled correctly. Align hopper front triangle with [ ] bowl triangle [ OPEN ] first and turn it to clockwise until it clicks so that the hopper triangle [ ] aligned with bowl triangle [Close ]. Hopper rear part 2,3 Make sure to press the screw down into the strainer as in STEP 2.
HOW TO USE THE APPLIANCE JUICE CAP AND EXTRACTION PACKING BACK VIEW JUICE CAP This is the cap of juice outlet in the bowl. Close the juice cap and fill up with juice in the bowl with various ingredients. You can easily make mixed juices. Juice cap Close juice cap and press [ON] button to start. When juice starts filling up the bowl, you can mix banana, nuts, boiled sweet potato etc. and liquids such as milk etc. as well as vegetables and fruits like smoothies.
WHEN THE SCREW IS STOPPED DURING OPERATION (REVERSE/REV BUTTON) IMPORTANT SAFEGUARDS IN USE • Fruits with pits, hard seeds such as nectarines, peaches, mangos, apricots, plums and cherries must be pitted before juicing. Click [ Reverse/REV ] button and stop the appliance. • Cut fibrous ingredients (water parsley setc.) in small size like 3~4cm (1.5inch) and place to the feeding tube • Drink the fruit juice or green vegetable juice immediately after you have extracted.
DISASSEMBLY, CLEANING AND CARE DISASSEMBLY, CLEANING AND CARE FIGURE IN ORDER 1. Ensure the motor stops completely and unplug the power cord. When unplugging the power cord, hold the head part of the power cord and unplug it. Do not touch the power cord with wet hands. 2. Hold the juice outlet and the hopper with both hands and lift them up from the base. 3. Disassemble the parts as below: Juice outlet 1) Unlock the bowl twisting to counterclockwise. 2) Take the screw out. 3) Remove the strainer.
BOWL DISASSEMBLY AND WASH STERILIZATION AND EASY CLEANING SYSTEM STERILIZATION Juice cap packing bowl packing 1 Remove Juice Cap packing and bowl packing. For sterilization, use baking soda or natural wash-up liquids only. Open juice cap first. Hold the bowl and juice cap with one hand and remove juice cap packing with the other hand. When removing it, be careful not to drop the juice cap and bowl. It may cause damage to the juice cap.
SPINNING BRUSH DISASSEMBLY AND WASH Remove the spinning brush from strainer. SPINNING BRUSH ASSEMBLY SPINNING BRUSH SILICONE BRUSH Inner wing UP (longer part) Brush groove Outer wing Check the groove of the spinning brush and the direction of silicone brush. There are grooves to insert silicone brush in the spinning brush. Silicone brush has inner wing and outer wing. As shown to the left, let ‘inner wing’ face the spinning brush.
BOWL PACKING ASSEMBLY JUICE CAP PACKING ASSEMBLY Hold the bowl packing like pinching. Hold juice cap packing as shown to the left. As shown to the left in a dotted circle, let the protrusion part on the bowl packing face upward and hold it like pinching with your thumb and index finger. Bowl packing Juice cap packing Insert the bowl packing into the bowl hole. Insert the bottom of the bowl packing into the bowl hole and fully press it down. Do not insert whole part of bowl packing.
TROUBLESHOOTING APPLIANCE SPECIFICATIONS Check the details below before contacting Technical Support for repair or service. If you need information or if you have a problem, please contact the local Customer Care Center. When applying for after sales service, check the manufacturer’s serial number or bar code. THE APPLIANCE DOES NOT WORK. Make sure the power cord is properly plugged in. Check the hopper is assembled properly.